Bob and Brenda's Gulbransen
PAGE THREE


Removing Steel Pin




Hole is threaded. Screws go into this to hold unit to manifold


Pneumatic/Valve on LEFTbefore disassembly - Apart on RIGHT


Fingers are glued and screwed to the pneumatic leaf. Screws are removed prior to heating



With Steel Pins removed, valve/pneumatic units are placed in microwave oven, where
after trials, the timing was determined to be 50 seconds with a setting of high.

After heating, the valve/pneumatic assembly is dis-assembled in the following order:

Valve/Pneumatic assemblys are hot. Wear Gloves. First remove wood finger

PAGE TWO              PAGE FOUR